checklist
This is an old revision of the document!
various check lists to avoid screwing up electronic manufacturing projects
before designing
parts:
- ensure you have enough parts locally
- prefer parts with high availability and multiple distributors
after designing
schematic:
- BOM: put part ordering information, or use description for generic parts
board:
- run rats nest to ensure all is connected
- run DRC
- ensure outline is present and uses 0.1 mm lines
- ensure the text next to the LEDs, header pins, and test points are the right ones
- place project/board name and version
- place ordering number text under a component, or on panel rails
- place reference designators for assembly
- check output gerbers
- print gerber and place components to check footprints (particularly if new) and spacing
checklist.1639578843.txt.gz · Last modified: 2024/01/07 17:49 (external edit)