usb-c_breakout_board
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| usb-c_breakout_board [2022/03/11 10:44] – add release kingkevin | usb-c_breakout_board [2022/03/11 18:28] – add shop kingkevin | ||
|---|---|---|---|
| Line 15: | Line 15: | ||
| For easy access to the pins I wanted standard 2.54 mm/100 mil headers. | For easy access to the pins I wanted standard 2.54 mm/100 mil headers. | ||
| So it can also be used to design or test devices I want it to be breadboard friendly (at least 400 mil spacing between the columns). | So it can also be used to design or test devices I want it to be breadboard friendly (at least 400 mil spacing between the columns). | ||
| - | To be able to tap signal or be man in the middle, I wanted them to be stackable (same form factor | + | To be able to tap signal or be man in the middle, I wanted them to be stackable (same form factor |
| You can already find USB-C breakout boards on AliExpress, but none fitted all aforementioned requirements. | You can already find USB-C breakout boards on AliExpress, but none fitted all aforementioned requirements. | ||
| Line 32: | Line 32: | ||
| But the USB 3.x SuperSpeed data lines SSTX+n/ | But the USB 3.x SuperSpeed data lines SSTX+n/ | ||
| Thus the signal integrity is not guaranteed. | Thus the signal integrity is not guaranteed. | ||
| + | |||
| + | ===== availability ===== | ||
| + | |||
| + | A few sets are available on [[https:// | ||
| + | You can also use the release files to manufacture some yourself. | ||
| ===== parts ===== | ===== parts ===== | ||
usb-c_breakout_board.txt · Last modified: 2024/01/07 17:49 by 127.0.0.1
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
