stm32f1xx
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| stm32f1xx [2020/02/12 01:18] – [blue pill] add black pill kingkevin | stm32f1xx [2020/02/12 08:58] – [blue pill] add pictures kingkevin | ||
|---|---|---|---|
| Line 119: | Line 119: | ||
| Mine for example has a 10 kΩ pull-up (to 3.3 V) resistor on USB D+/PA12 instead if a 4.7kΩ (to 5 V), although USB devices use a 1.5 kΩ resistor to pull up (to 3.3 V) usually. | Mine for example has a 10 kΩ pull-up (to 3.3 V) resistor on USB D+/PA12 instead if a 4.7kΩ (to 5 V), although USB devices use a 1.5 kΩ resistor to pull up (to 3.3 V) usually. | ||
| - | ===== blue pill ===== | + | ===== black pill ===== |
| + | |||
| + | {{ : | ||
| + | {{ : | ||
| the [[https:// | the [[https:// | ||
| Line 130: | Line 133: | ||
| changes: | changes: | ||
| * LED is on PB12 (sink to enable it) | * LED is on PB12 (sink to enable it) | ||
| + | * different pinout | ||
| drawbacks: | drawbacks: | ||
| * larger | * larger | ||
| Line 137: | Line 141: | ||
| * no VBAT pin | * no VBAT pin | ||
| * one less GND pin | * one less GND pin | ||
| - | * no C15 and C14 pin | + | * no C15 and C14 pin (used for OSC32) |
| - | * different pinout | + | |
| ===== core board ===== | ===== core board ===== | ||
stm32f1xx.txt · Last modified: 2024/01/07 17:49 by 127.0.0.1
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
