stm32f1xx
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
stm32f1xx [2017/07/24 10:54] – [maple mini] typo kingkevin | stm32f1xx [2018/01/28 11:51] – [USB DFU] add own bootloader kingkevin | ||
---|---|---|---|
Line 79: | Line 79: | ||
* no additional connections (SWD, power, GND) | * no additional connections (SWD, power, GND) | ||
* the pin silkscreen are not the chip pins (you always need the schematic at hand) | * the pin silkscreen are not the chip pins (you always need the schematic at hand) | ||
- | * the clones don't provide a second voltage regulator for the analogue | + | * the clones don't provide a second voltage regulator for the analog |
===== blue pill ===== | ===== blue pill ===== | ||
Line 364: | Line 364: | ||
==== USB DFU ==== | ==== USB DFU ==== | ||
- | There are several USB DFU bootloader. | + | There are several USB DFU bootloaders available (one from [[http:// |
- | I am using [[https:// | + | |
- | It works well on most generic | + | Here I will explain how to use USB DFU with the [[https:// |
If you want to make use of USB in your actual application after the bootloader started it, don't forget to force re-enumerating USB so the host computer sees the new interface: | If you want to make use of USB in your actual application after the bootloader started it, don't forget to force re-enumerating USB so the host computer sees the new interface: |
stm32f1xx.txt · Last modified: 2024/01/07 17:49 by 127.0.0.1