Differences

This shows you the differences between two versions of the page.

--- printer_cartridge [2019/04/15 06:17] – [identifying cartridge chip] update link kingkevin
+++ printer_cartridge [2019/04/15 06:32] – [implementing DS2432] typo kingkevin
@@ Line 60: / Line 60: @@
   * since the printer tries 4 times reading out the authenticated page using the same challenge there is plenty of time to forward the request and use an original chip as oracle
   * the print is done before updating the toner level, thus you could completely ignore the corresponding write commands
-  * even if you use an original chip a oracle, the write success is not authenticated, thus you can fake that the write succeeded when you are MitM, if the printer doesn't read the authenticated value afterwards to ensure the write took place
+  * even if you use an original chip as oracle, the write success is not authenticated, thus you can fake that the write succeeded when you are MitM, if the printer doesn't read the authenticated value afterwards to ensure the write took place
   * the printer starts by reading memory page 1 without authentication. Maybe there is some field in there allowing to switch to god mode (e.g. developer mode), which does not require authentication