megacode
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
megacode [2016/03/31 17:48] – update git link kingkevin | megacode [2022/02/10 11:15] – update git links kingkevin | ||
---|---|---|---|
Line 114: | Line 114: | ||
The recorded data can be view in audio editing tools such as [[http:// | The recorded data can be view in audio editing tools such as [[http:// | ||
- | The code can also be extracted using [[https:// | + | The code can also be extracted using [[https:// |
< | < | ||
./decode.rb megacode.pcm | ./decode.rb megacode.pcm | ||
Line 151: | Line 151: | ||
{{: | {{: | ||
- | The firmware is available in [[https:// | + | The firmware is available in [[https:// |
- | You can define the code to transmit in [[https:// | + | You can define the code to transmit in [[https:// |
==== ACT-34B ==== | ==== ACT-34B ==== | ||
Line 162: | Line 162: | ||
{{: | {{: | ||
- | The firmware is available in [[https:// | + | The firmware is available in [[https:// |
The two right buttons are used to send codes defined in the source. | The two right buttons are used to send codes defined in the source. | ||
I planned to use the two left buttons to brute force codes but did not finish the implementation. | I planned to use the two left buttons to brute force codes but did not finish the implementation. | ||
Line 178: | Line 178: | ||
The {{: | The {{: | ||
- | The firmware receiving and recording codes is available in [[https:// | + | The firmware receiving and recording codes is available in [[https:// |
- | How it works and how to use it further is described in the [[https:// | + | How it works and how to use it further is described in the [[https:// |
All codes are read out over I²C when the board is powered up. | All codes are read out over I²C when the board is powered up. | ||
They can be recorded/ | They can be recorded/ | ||
- | The original way the codes are recorded by the device in the EEPROM is described in the [[https:// | + | The original way the codes are recorded by the device in the EEPROM is described in the [[https:// |
==== MDR-U ==== | ==== MDR-U ==== | ||
Line 193: | Line 193: | ||
Same as for the MDR, I de-soldered the PIC16C54A micro-controller and replaced it with a pin compatible PIC16F1847 (SOIC version). | Same as for the MDR, I de-soldered the PIC16C54A micro-controller and replaced it with a pin compatible PIC16F1847 (SOIC version). | ||
The firmware is the same as the MDR. | The firmware is the same as the MDR. | ||
+ | |||
+ | ==== RF module ==== | ||
+ | |||
+ | aaronsp777 [[https:// |
megacode.txt · Last modified: 2024/01/07 17:49 by 127.0.0.1