This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
dump_spi_flash [2021/04/15 11:23] – [interface] kingkevin | dump_spi_flash [2024/01/07 17:49] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 177: | Line 177: | ||
There I can save read/write the data content, and save/load it. | There I can save read/write the data content, and save/load it. | ||
- | To get the latest chip database (particularly if the Linux release it lagging), here how I update it: | + | To get the latest chip database (particularly if the Linux release it lagging), here how I update it ([[https:// |
< | < | ||
Line 236: | Line 236: | ||
This allows to customize the programmer to your needs and setup (regarding voltage level, clock speed, nRST pin of flash and MCU, ...). | This allows to customize the programmer to your needs and setup (regarding voltage level, clock speed, nRST pin of flash and MCU, ...). | ||
- | ===== electrical ===== | + | ===== electrical |
The most important part is using the right voltage so you don't damage the target chip or board. | The most important part is using the right voltage so you don't damage the target chip or board. |