This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
dump_spi_flash [2021/04/15 11:23] – [interface] kingkevin | dump_spi_flash [2021/04/15 11:24] – [electrical] kingkevin | ||
---|---|---|---|
Line 236: | Line 236: | ||
This allows to customize the programmer to your needs and setup (regarding voltage level, clock speed, nRST pin of flash and MCU, ...). | This allows to customize the programmer to your needs and setup (regarding voltage level, clock speed, nRST pin of flash and MCU, ...). | ||
- | ===== electrical ===== | + | ===== electrical |
The most important part is using the right voltage so you don't damage the target chip or board. | The most important part is using the right voltage so you don't damage the target chip or board. |