This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
checklist [2021/12/15 14:34] – created kingkevin | checklist [2024/01/07 17:49] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 15: | Line 15: | ||
* run rats nest to ensure all is connected | * run rats nest to ensure all is connected | ||
* run DRC | * run DRC | ||
+ | * ensure non-plated through hole (e.g. mounting hole) have copper clearance (else it will be manufactured as plated hole) | ||
* ensure outline is present and uses 0.1 mm lines | * ensure outline is present and uses 0.1 mm lines | ||
* ensure the text next to the LEDs, header pins, and test points are the right ones | * ensure the text next to the LEDs, header pins, and test points are the right ones | ||
+ | * remove floating trace stubs (disable pad/ | ||
* place project/ | * place project/ | ||
* place ordering number text under a component, or on panel rails | * place ordering number text under a component, or on panel rails | ||
* place reference designators for assembly | * place reference designators for assembly | ||
+ | * check solder mask (e.g. tented holes) and solder paste (e.g. through hole pins) | ||
+ | * check outline copper pullback | ||
* check output gerbers | * check output gerbers | ||
* print gerber and place components to check footprints (particularly if new) and spacing | * print gerber and place components to check footprints (particularly if new) and spacing |