checklist
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
checklist [2021/12/16 13:20] – add mask and paste kingkevin | checklist [2022/03/23 09:24] – [after designing] kingkevin | ||
---|---|---|---|
Line 17: | Line 17: | ||
* ensure outline is present and uses 0.1 mm lines | * ensure outline is present and uses 0.1 mm lines | ||
* ensure the text next to the LEDs, header pins, and test points are the right ones | * ensure the text next to the LEDs, header pins, and test points are the right ones | ||
+ | * remove floating trace stubs (disable pad/ | ||
* place project/ | * place project/ | ||
* place ordering number text under a component, or on panel rails | * place ordering number text under a component, or on panel rails | ||
* place reference designators for assembly | * place reference designators for assembly | ||
* check solder mask (e.g. tented holes) and solder paste (e.g. through hole pins) | * check solder mask (e.g. tented holes) and solder paste (e.g. through hole pins) | ||
+ | * check outline copper pullback | ||
* check output gerbers | * check output gerbers | ||
* print gerber and place components to check footprints (particularly if new) and spacing | * print gerber and place components to check footprints (particularly if new) and spacing |
checklist.txt · Last modified: 2024/01/07 17:49 by 127.0.0.1