led_light_controller
Differences
This shows you the differences between two versions of the page.
Next revisionBoth sides next revision | |||
led_light_controller [2015/02/21 12:08] – created kingkevin | led_light_controller [2015/02/21 12:17] – [firmware] kingkevin | ||
---|---|---|---|
Line 26: | Line 26: | ||
The source files are available on [[https:// | The source files are available on [[https:// | ||
PDF and gerber of schematich and layout are available in {{led_light_controller: | PDF and gerber of schematich and layout are available in {{led_light_controller: | ||
+ | |||
+ | ======= firmware ====== | ||
+ | |||
+ | The board uses an Atmel ATmega328P micro-controller. | ||
+ | It allows to set the brightness of the LED strips using PWM. | ||
+ | This can be controlled over the serial port or an infra-red remote using NEC codes. | ||
+ | 2x5 channels are provided by the board. | ||
+ | 3 modes are used to save brightness settings. | ||
+ | |||
+ | The source code is available on [[https:// | ||
+ | The firmware binary is available {{led_light_controller: |
led_light_controller.txt · Last modified: 2024/01/07 17:49 by 127.0.0.1