Differences

This shows you the differences between two versions of the page.

--- jtag [2018/02/04 12:14] – [Black Magic Probe] update DFU flashing information kingkevin
+++ jtag [2018/12/09 19:50] – [ST-LINK/V2 clone] kingkevin
@@ Line 61: / Line 61: @@
 {{:jtag:mb936_case-front.jpg?0x150|case front}}
 {{:jtag:mb936_case-back.jpg?0x150|case back}}
-{{:jtag:mb936_internal-front.jpg?0x150|internal front}}
 {{:jtag:mb936_internal-front2.jpg?0x150|internal front}}
 {{:jtag:mb936_internal-back.jpg?0x150|internal back}}
@@ Line 121: / Line 120: @@
 This one has an "M" logo instead of the ST logo, probably corresponding to the "MX-LINK V2" marking on the board.
 ==== Baite ====
@@ Line 351: / Line 351: @@
 {{:jtag:mini_stm32_front-board.jpg?0x150|ARMJISHU board USB-Blaster front}}
 {{:jtag:mini_stm32_back-board.jpg?0x150|ARMJISHU board USB-Blaster back}}
 ===== SEGGER J-Link =====
@@ Line 362: / Line 363: @@
 That makes it the most complete JTAG adapter I have.
+===== Texas Instruments XDS100v3 =====
+The [[http://processors.wiki.ti.com/index.php/XDS100|XDS100v3]] supports cJTAG (aka. IEEE 1149.7, or SWD alternative), but I did not have the opportunity to test it yet.
+{{:jtag:xds100v3_case.jpg?0x150|device}}
+{{:jtag:xds100v3_front.jpg?0x150|board front}}
+{{:jtag:xds100v3_back.jpg?0x150|board back}}
+===== DISTORTEC JTAG-lock-pick Tiny 2 =====
+The [[http://www.distortec.com/jtag-lock-pick-tiny-2/|JTAG-lock-pick Tiny 2]] is just a very fast (using a FT232H chip), and compact (although it could be even more compact if the component were on both sides) JTAG adapter supporting 1.4V to 5.5V signals (using a CPLD), RTCK, SRST, and TRST.
+{{:jtag:jtag-lockpick_front.jpg?0x150|board front}}
+{{:jtag:jtag-lockpick_back.jpg?0x150|board back}}
 ====== tricks ======