Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
| jtag [2017/09/06 14:38] – [ST-LINK/V2 clone] kingkevin | jtag [2017/09/06 14:57] – [Baite] kingkevin |
|---|
| The [[http://betemcu.cn/|Baite]] [[https://www.aliexpress.com/store/product/Best-Quality-ST-Link-stlink-V2-for-STM8S-STM8L-STM32-Cortex-M0-Cortex-M3-SWIM-JTAG/213957_32676015777.html|ST-Link V2]] is my favorite clone since it supports JTAG, SWD, and SWIM (for STM8). | The [[http://betemcu.cn/|Baite]] [[https://www.aliexpress.com/store/product/Best-Quality-ST-Link-stlink-V2-for-STM8S-STM8L-STM32-Cortex-M0-Cortex-M3-SWIM-JTAG/213957_32676015777.html|ST-Link V2]] is my favorite clone since it supports JTAG, SWD, and SWIM (for STM8). |
| |
| The seem to use the same board also for several other programmers, and since the pinout is not on the case I've decided to make my own sticker. | They seem to use the same board also for several other programmers, and since the pinout is not on the case I've decided to make my own sticker. |
| |
| {{:jtag:dsc02406.jpg?0x100|pinout sticker}} | {{:jtag:dsc02406.jpg?0x100|pinout sticker}} |
| {{:jtag:baite-v2a-board_back.jpg?0x100|board front}} | {{:jtag:baite-v2a-board_back.jpg?0x100|board front}} |
| |
| There is a newer version marked as "V2A" (under the crystal), but the {{:jtag:baite-v2a.pdf|schematic}} is pretty much the small with the following changes: | There is a newer version marked as "V2A" (under the crystal), but the {{:jtag:baite-v2a.pdf|schematic}} is pretty much the same with the following changes: |
| * all pads for the micro-controller are present (there is even solder mask between them) | * all pads for the micro-controller are present (there is even solder mask between them) |
| * they added a SWD port | * they added a SWD port |
