jtag
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| jtag [2017/04/25 14:05] – [Baite] kingkevin | jtag [2017/04/25 14:07] – kingkevin | ||
|---|---|---|---|
| Line 183: | Line 183: | ||
| First we need to re-program the Baite dongle.\\ | First we need to re-program the Baite dongle.\\ | ||
| - | As you can see on the {{:jtag:baite_schematic.pdf|schematic}} the JTAG and SWD pins of the micro-controller are not connected (there even are no pads on the board for the pins to be soldered on). | + | As you can see on the {{:jtag:baite.pdf|schematic}} the JTAG and SWD pins of the micro-controller are not connected (there even are no pads on the board for the pins to be soldered on). |
| But on the back of the board you can find test points so to program the device using the serial bootloader: | But on the back of the board you can find test points so to program the device using the serial bootloader: | ||
jtag.txt · Last modified: 2024/01/07 17:49 by 127.0.0.1