Differences

This shows you the differences between two versions of the page.

--- jtag [2017/04/13 14:44] – [ST-LINK V2 aluminium] kingkevin
+++ jtag [2017/04/25 14:07] – kingkevin
@@ Line 111: / Line 111: @@
 {{:jtag:reverse-gnd_internal-back.jpg?0x100|}}
-From the outside this looks very similar to the previous one, except that the connector pinout is very different (except for power).\\
+From the outside this looks very similar to the previous one, except that the connector pinout is very different (except for power) and there is only one LED.\\
 No markings are on the board.
@@ Line 135: / Line 135: @@
 {{:jtag:st-link_v2_baite.svg?0x100|pinout}}
-I've also reversed the board layout to get the {{:jtag:baite_schematic.pdf|schematic}}.
+I've also reversed the board layout to get the {{:jtag:baite.pdf|schematic}}.
 The connector pins are all protected with 220 ohms resistors.
@@ Line 141: / Line 141: @@
 {{:jtag:baite-v2a-board_back.jpg?0x100|board front}}
-There is a newer version marked as "V2A", but the {{:jtag:baite-v2a.pdf|schematic}} is pretty much the small with the following changes:
+There is a newer version marked as "V2A" (under the crystal), but the {{:jtag:baite-v2a.pdf|schematic}} is pretty much the small with the following changes:
   * all pads for the micro-controller are present (there is even solder mask between them)
   * they added a SWD port
@@ Line 183: / Line 183: @@
 First we need to re-program the Baite dongle.\\
-As you can see on the {{:jtag:baite_schematic.pdf|schematic}} the JTAG and SWD pins of the micro-controller are not connected (there even are no pads on the board for the pins to be soldered on).
+As you can see on the {{:jtag:baite.pdf|schematic}} the JTAG and SWD pins of the micro-controller are not connected (there even are no pads on the board for the pins to be soldered on).
 But on the back of the board you can find test points so to program the device using the serial bootloader: