Differences

This shows you the differences between two versions of the page.

--- jtag [2017/04/13 14:44] – [ST-LINK V2 aluminium] kingkevin
+++ jtag [2017/04/25 14:04] – [ST-LINK V2 aluminium] kingkevin
@@ Line 111: / Line 111: @@
 {{:jtag:reverse-gnd_internal-back.jpg?0x100|}}
-From the outside this looks very similar to the previous one, except that the connector pinout is very different (except for power).\\
+From the outside this looks very similar to the previous one, except that the connector pinout is very different (except for power) and there is only one LED.\\
 No markings are on the board.
@@ Line 141: / Line 141: @@
 {{:jtag:baite-v2a-board_back.jpg?0x100|board front}}
-There is a newer version marked as "V2A", but the {{:jtag:baite-v2a.pdf|schematic}} is pretty much the small with the following changes:
+There is a newer version marked as "V2A" (under the crystal), but the {{:jtag:baite-v2a.pdf|schematic}} is pretty much the small with the following changes:
   * all pads for the micro-controller are present (there is even solder mask between them)
   * they added a SWD port