Differences

This shows you the differences between two versions of the page.

--- jtag [2017/03/30 16:02] – [Black Magic Probe] note kingkevin
+++ jtag [2017/04/03 10:26] – [Black Magic Probe] add pinout kingkevin
@@ Line 125: / Line 125: @@
 {{:jtag:baite_board_back.jpg?0x100|board front}}
-The [[https://www.aliexpress.com/store/213957|Baite]] [[https://www.aliexpress.com/store/product/Best-Quality-ST-Link-stlink-V2-for-STM8S-STM8L-STM32-Cortex-M0-Cortex-M3-SWIM-JTAG/213957_32676015777.html|ST-Link V2]] is my favorite clone since it supports JTAG, SWD, and SWIM (for STM8).
+The [[http://betemcu.cn/|Baite]] [[https://www.aliexpress.com/store/product/Best-Quality-ST-Link-stlink-V2-for-STM8S-STM8L-STM32-Cortex-M0-Cortex-M3-SWIM-JTAG/213957_32676015777.html|ST-Link V2]] is my favorite clone since it supports JTAG, SWD, and SWIM (for STM8).
 The seem to use the same board also for several other programmers, and since the pinout is not on the case I've decided to make my own sticker.
@@ Line 213: / Line 213: @@
 or short RX to ground (pin 5 and 7) to force the DFU bootloader start when plugin in the dongle (in case the main application is buggy).
-Here is the new "BMP Baite" pinout:
+Here is the new "BMP Baite" {{ :jtag:bmp_baite.pdf |pinout}}:
 ^ signal ^ pin ^ pin ^ signal ^
 | SRST | 1 | 2| +3.3V |