Differences

This shows you the differences between two versions of the page.

--- jtag [2017/03/30 15:46] – add BMP kingkevin
+++ jtag [2017/04/03 10:26] – [Black Magic Probe] add pinout kingkevin
@@ Line 125: / Line 125: @@
 {{:jtag:baite_board_back.jpg?0x100|board front}}
-The [[https://www.aliexpress.com/store/213957|Baite]] [[https://www.aliexpress.com/store/product/Best-Quality-ST-Link-stlink-V2-for-STM8S-STM8L-STM32-Cortex-M0-Cortex-M3-SWIM-JTAG/213957_32676015777.html|ST-Link V2]] is my favorite clone since it supports JTAG, SWD, and SWIM (for STM8).
+The [[http://betemcu.cn/|Baite]] [[https://www.aliexpress.com/store/product/Best-Quality-ST-Link-stlink-V2-for-STM8S-STM8L-STM32-Cortex-M0-Cortex-M3-SWIM-JTAG/213957_32676015777.html|ST-Link V2]] is my favorite clone since it supports JTAG, SWD, and SWIM (for STM8).
 The seem to use the same board also for several other programmers, and since the pinout is not on the case I've decided to make my own sticker.
@@ Line 213: / Line 213: @@
 or short RX to ground (pin 5 and 7) to force the DFU bootloader start when plugin in the dongle (in case the main application is buggy).
-Here is the new "BMP Baite" pinout:
+Here is the new "BMP Baite" {{ :jtag:bmp_baite.pdf |pinout}}:
 ^ signal ^ pin ^ pin ^ signal ^
 | SRST | 1 | 2| +3.3V |
@@ Line 220: / Line 220: @@
 | GND | 7 | 8 | JTDO/TRACESWO |
 | TX | 9 | 10 | JTDI |
+**note**: the RX pin is pulled up by a 620 ohms resistor. Thus the TX connected to BMP Baite must by strong enough to drive it low (e.g. not like with the CH340 USB to UART converter).
 If you connect SRST to the target NRST, it is even possible to reset the target board without having to press on the on-board reset button (of there is any):