Differences

This shows you the differences between two versions of the page.

--- jtag [2017/03/30 13:38] – [aluminium] kingkevin
+++ jtag [2017/03/30 13:52] – [BAITE] kingkevin
@@ Line 118: / Line 118: @@
 This one has an "M" logo instead of the ST logo, probably corresponding to the "MX-LINK V2" marking on the board.
-==== BAITE ====
+==== Baite ====
-The first clone is a [[http://www.aliexpress.com/item/Free-Shipping-1SET-ST-Link-st-link-V2-for-STM8S-STM8L-STM32-Cortex-M0-Cortex-M3/1758613434.html|BAITE]] ST-Link V2.
-It supports JTAG, SWD, and SWIM (for STM8).
-{{:jtag:dsc02404.jpg?0x100|device front}}
+{{:jtag:baite_dongle_front.jpg?0x100|dongle front}}
-{{:jtag:dsc02405.jpg?0x100|device back}}
+{{:jtag:baite_dongle_back.jpg?0x100|dongle back}}
-{{:jtag:dsc02403.jpg?0x100|PCB front}}
+{{:jtag:baite_board_front.jpg?0x100|board front}}
+{{:jtag:baite_board_back.jpg?0x100|board front}}
+The [[https://www.aliexpress.com/store/213957|Baite]] [[https://www.aliexpress.com/store/product/Best-Quality-ST-Link-stlink-V2-for-STM8S-STM8L-STM32-Cortex-M0-Cortex-M3-SWIM-JTAG/213957_32676015777.html|ST-Link V2]] is my favorite clone since it supports JTAG, SWD, and SWIM (for STM8).
+The seem to use the same board also for several other programmers, and since the pinout is not on the case I've decided to make my own sticker.
 {{:jtag:dsc02406.jpg?0x100|pinout sticker}}
 {{:jtag:st-link_v2_baite.svg?0x100|pinout}}
+I've also reversed the board layout to get the {{:jtag:baite_schematic.pdf|schematic}}.
+The connector pins are all protected with 220 ohms resistors.
 STM32F103C8 connection:
@@ Line 144: / Line 151: @@
 | PB5 | 41 |  | LED |
-the adapter pins are protected with a 220 ohms resistor.
 ===== Altera USB-Blaster =====