Differences

This shows you the differences between two versions of the page.

--- jtag [2016/02/03 13:47] – [ST-Link v2 (clone)] add pinout kingkevin
+++ jtag [2016/02/12 09:59] – add st-link v2 stm32 pinout kingkevin
@@ Line 30: / Line 30: @@
 | USB VCC |  | 3 | 5V |
 | PA4 | 14 | 4 | JTCK/SWCLK |
-| PB11 | 22 | 5 | SWIM/SWDIO |
+| PB11 | 22 | 5 | SWIM |
-| PA14 | 37 | 6 | JTMS |
+| PA14 | 37 | 6 | JTMS/SWDIO |
 | USB GND |  | 7 | GND |
 | PA5 | 15 | 8 | JTDO |
@@ Line 46: / Line 46: @@
 {{:jtag:dsc02415.jpg?0x100|PCB front}}
 {{:jtag:dsc02410.jpg?0x100|PCB back}}
+^ STM32F103C8 signal ^ STM32F103C8 pin ^ adapter pin ^ adapter signal ^
+| PB6 | 42 | 1 | RST |
+| PB14 | 27 | 2 | SWDIO |
+| USB GND |  | 3 | GND |
+| USB GND |  | 4 | GND |
+| PB8/PB11 | 45/22 | 5 | SWIM |
+| PA5/PB13 | 15/26 | 6 | SWCLK |
+| LDO VCC |  | 7 | 3.3V |
+| LDO VCC |  | 8 | 3.3V |
+| USB VCC |  | 9 | 5V |
+| USB VCC  |  | 10 | 5V |
+| PA9 | 30 | current source  | LED |
 These devices use the Serial Wire Debug (SWD) protocol.