Differences

This shows you the differences between two versions of the page.

--- jtag [2016/01/13 08:57] – [scan chain] kingkevin
+++ jtag [2016/01/13 09:02] – [Altera USB-Blaster (clone)] kingkevin
@@ Line 133: / Line 133: @@
 </code>
+Now you can also use it, here with an STM32F1 micro-controller:
+<code bash>
+openocd --file interface/altera-usb-blaster.cfg --file target/stm32f1x.cfg
+Open On-Chip Debugger 0.10.0-dev-00189-g554313b (2016-01-12-16:26)
+Licensed under GNU GPL v2
+For bug reports, read
+	http://openocd.org/doc/doxygen/bugs.html
+Warn : Adapter driver 'usb_blaster' did not declare which transports it allows; assuming legacy JTAG-only
+Info : only one transport option; autoselect 'jtag'
+adapter speed: 1000 kHz
+adapter_nsrst_delay: 100
+jtag_ntrst_delay: 100
+none separate
+cortex_m reset_config sysresetreq
+Info : No lowlevel driver configured, will try them all
+Info : usb blaster interface using libftdi
+Error: unable to get latency timer
+Info : This adapter doesn't support configurable speed
+Info : JTAG tap: stm32f1x.cpu tap/device found: 0x3ba00477 (mfg: 0x23b, part: 0xba00, ver: 0x3)
+Info : JTAG tap: stm32f1x.bs tap/device found: 0x16410041 (mfg: 0x020, part: 0x6410, ver: 0x1)
+Info : stm32f1x.cpu: hardware has 6 breakpoints, 4 watchpoints
+</code>
 ===== tricks =====