CuVoodoo

the sorcery of copper

User Tools

Site Tools


ea-ps_2084-03b

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
ea-ps_2084-03b [2015/06/07 19:03] – add picture kingkevinea-ps_2084-03b [2015/06/08 10:43] – [power supply] kingkevin
Line 57: Line 57:
 It will set the voltage and current which are set, actual (measured by the power supply), and [[#mutlimeter|measured]] (measured by the DMM) It will set the voltage and current which are set, actual (measured by the power supply), and [[#mutlimeter|measured]] (measured by the DMM)
  
 +Using [[https://git.cuvoodoo.info/kingkevin/ea-ps_2084-03b/blob/master/probe.rb|this script]] I could also find the following undocumented objects (for commands): 80, 81, 82, 83, 84, 85, 86, 87, 88, 149, 150, 151, 152, 156, 158, 160, 161, 162.
 +These probably allow you to flash the firmware or calibrate the power supply.
 ===== multimeter ===== ===== multimeter =====
  
Line 78: Line 80:
 Finally I found a FT232-based RS232 to USB converter. Finally I found a FT232-based RS232 to USB converter.
 This is an expensive cable (but good quality), from an evil company, and it worked. This is an expensive cable (but good quality), from an evil company, and it worked.
 +
 +Here is the schematic of this cable:
 +
 +{{:ea-ps_2084-03b:ut-d02.svg?400|}}
  
 But instead of using it, I decided to connect the cable to a CP2102-based UART to USB converter. But instead of using it, I decided to connect the cable to a CP2102-based UART to USB converter.
Line 173: Line 179:
 {{:ea-ps_2084-03b:dsc02162-mini.jpg?200|}} {{:ea-ps_2084-03b:dsc02162-mini.jpg?200|}}
  
 +====== conclusion ======
 +
 +pro:
 +  * fulfils all initial power supply criteria 
 +  * **set output is within accuracy**
 +  * good design, lay out, quality components
 +  * fast first contact response
 +
 +contra:
 +  * output is not switched of completely
 +  * **measured value is up to 0.4 V lower than output voltage**
 +  * second digit after . of voltage is always 0 and not settable (it should not be displayed in this case)
 +  * second digit after . of voltage is always 0 and does not show measured value (the actual measured data is precise enough to show this digit)
 +  * can skip fast knob turns
 +  * USB cable does no fit in port because of the indent
 +  * information in english programming manual missing
 +  * small mistakes in programming manual
 +  * can not be calibrated by end user, and vendor only calibrates if under warranty
 +  * no contact support
ea-ps_2084-03b.txt · Last modified: 2024/01/07 17:49 by 127.0.0.1