busvoodoo
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
busvoodoo [2017/12/22 17:00] – [features] low speed kingkevin | busvoodoo [2017/12/22 18:30] – add pictures kingkevin | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | The BusVoodoo is a multi-protocol debugging adapter. | + | {{ : |
+ | |||
+ | The BusVoodoo is a multi-protocol debugging adapter.\\ | ||
This tool allows to quickly communicate with various other electronic devices. | This tool allows to quickly communicate with various other electronic devices. | ||
Line 5: | Line 7: | ||
The BusVoodoo is a multi-protocol debugging adapter. | The BusVoodoo is a multi-protocol debugging adapter. | ||
+ | |||
It comes it two versions: | It comes it two versions: | ||
Line 11: | Line 14: | ||
The light version can be converter to a full version by populating the components on the bottom side of the PCB (and cutting the display and RS/CAN slots in the case) | The light version can be converter to a full version by populating the components on the bottom side of the PCB (and cutting the display and RS/CAN slots in the case) | ||
+ | [{{ : | ||
+ | [{{: | ||
+ | |||
+ | {{ : | ||
Device features: | Device features: | ||
* compact case: 56.0x27.7x14.7 mm | * compact case: 56.0x27.7x14.7 mm | ||
Line 20: | Line 27: | ||
* re-flashable with [[# | * re-flashable with [[# | ||
+ | {{ : | ||
I/O connector: | I/O connector: | ||
* 2x5 pins header (IDC, 2.54 mm pitch) | * 2x5 pins header (IDC, 2.54 mm pitch) | ||
Line 29: | Line 37: | ||
- 6 I/O pins, 3.3 V in push-pull mode (protected using 220 Ohm resistors), 1.6 to 5.5 V in open-drain mode using strong 2 kOhm embedded pull-up resistors (with internal adjustable voltage regulator or external power source) | - 6 I/O pins, 3.3 V in push-pull mode (protected using 220 Ohm resistors), 1.6 to 5.5 V in open-drain mode using strong 2 kOhm embedded pull-up resistors (with internal adjustable voltage regulator or external power source) | ||
+ | {{ : | ||
RS/CAN connector: | RS/CAN connector: | ||
* 1x5 pin header (IDC, 2.54 mm pitch) | * 1x5 pin header (IDC, 2.54 mm pitch) | ||
Line 36: | Line 45: | ||
* CAN port (not terminated) | * CAN port (not terminated) | ||
+ | {{ : | ||
programming connector: | programming connector: | ||
* on the board (in the bottom left corner) there is a 2x4 connector (2 mm pitch) | * on the board (in the bottom left corner) there is a 2x4 connector (2 mm pitch) |